ABL Wallbox eM4 Twin Bedienungsanleitung/Sicherheitshinweise Seite 29

The wallbox must under no circumstances be cleaned with a pressure cleaner or similar device.
x
Check the housing and the charging sockets of the wallbox regularly for any damage.
x
Reading the energy meter
Each charge point of the Wallbox eM4 Twin has its own energy meter that shows various information about the
charging operation via the three display lines. In contrast to the top line, the values displayed in lines 2 and 3 are
switched cyclically:
Total electric energy consumed
A
The top line always shows the total electric power
consumed in kWh, and therefore the sum of all the
electrical charge obtained via this particular charge
point. This line is not switched.
Current or last electric energy consumed
B
In this state, the second line shows the electric
energy in kWh during the active (
( ) charging process.
Charge point allocation
C
After switching, the second line on the left-hand side
shows the identification that was assigned to the
charge point during installation.
Malfunction display
D
In this state, the third line shows the code for identi-
fying a malfunction (error, note, warning).
Duration of the charging operation
E
After switching, the second line in this state shows
the duration of the active charging operation in
hours, minutes and seconds.
Current electric power consumption
F
In this state, the third line shows the active power
that is currently being drawn by the vehicle: During
charging, the value varies dynamically; without a
vehicle connected, the value is 0.0 kW.
) or completed
A
B
A
C
D
A
E
F
Reading the energy meter 29