ABL Wallbox eM4 Twin Bedienungsanleitung/Sicherheitshinweise Seite 25

ATTENTION
RFID card not readable
If the antenna of your RFID card is blocked or damaged, the card cannot be recognised.
Remove the RFID card from its protective cover or card holder to register at the RFID reader.
x
Do not make any modifications to the RFID card: The card must never be perforated, stamped, folded, have
x
stickers attached, or otherwise be manipulated mechanically.
Make sure that the RFID card corresponds to a standard that is supported by the wallbox. You can find
x
further information in the comprehensive installation manual.
7 Check the status indicator of the charge point
(display: 1 cycle).
After a request by the vehicle, the charging
x
operation in process is displayed dynamically
via the blue status indicator for the charge
point.
When the charging operation is complete, it is
x
automatically terminated by the vehicle, and
the status indicator for the charge point lights
up solid blue.
NOTE
No charging request or interruption of the charging operation
The status indicator for the charge point also lights up solid blue under the following circumstances:
The charging operation has not yet been started or has been paused by the vehicle.
x
The charging operation has not yet been started or has been paused by the internal load management. You
x
can find further information in the comprehensive installation manual.
8 Unplug the charging connector from the vehicle's
charging inlet and close it.
9 Unplug the charging plug from the charging socket
of the wallbox and store the charging cable. The
charge point lid closes automatically.
10 The wallbox is ready for operation and awaits the
next charging procedure (illustration: 1 cycle)
Charging procedure 25