Berner 43285 Bedienungsanleitung Seite 6

Battery Tester 043285
Always exercise extreme caution when handling batteries because of the
possible risk of injury. Observe the safety instructions of the BCI (Battery
Council International).
Battery terminals, battery connections and corresponding accessories contain
lead and lead compounds. According to information from the State of
California, these substances are classified as carcinogenic and can also
cause birth defects or fertility problems. Wash your hands after contact with
these substances.
General Functional description
The battery and electrical test device is suitable for testing normal, AGM
and gel batteries with a nominal voltage of 12 volts and for testing 12 V
starter and charging systems in passenger cars and vans. The test result
is displayed within seconds and can be printed out with the integrated
printer so that a receipt is available for the customer.
Other functions:
• Testing batteries with a cold start current of 100 to 900 CCA
• Defective cell detection
• Reverse polarity protection
• Testing discharged batteries
• Tests in various standards systems
(CCA, SAE, DIN, EN, IEC)
• Multilingual user interface with 19 languages
Display and Keypad
When the tester is connected to a battery for the first time, the unit
operates as a voltmeter until you press the ENTER button.
IMPORTANT: If the tester is connected to a voltage above 30 VDC, the
electronics of the unit may be damaged.
The menu-guided display guides you step by step through the test
procedure. Use the buttons on the keypad to switch between the different
menus and select options.
!
ATTENTION
5
- -