Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Battery Tester 043285
Battery test results
Assessment
BATTERY GOOD
GOOD - RELOAD
LOAD & CHECK
BATT. REPLACE
CELL CLOSURE
If you have performed a test outside the vehicle, the display content
alternates between the test results and the message ⮠ FOR PRINTING.
Since the printer is powered by the tested battery
is supplied, its voltage must be above 9 volts. Leave the
Press the ENTER key to connect the printer to the terminals and press
ENTER. For more information about the printer, see "Changing the printer
paper" and "Troubleshooting printer problems" on pages 17 and 18.
If you want to stop the process before printing, loosen the clamps. Do not
forget to print the test results before the next test.
IMPORTANT: Only the results of the last test are saved in the test
device. As soon as you start a new test, the last results are overwritten.
Testing the starter system
When you have completed a test with the battery installed, the display
content alternates between the test results and the message PRESS ⮠
FOR START TEST. At the appropriate
Prompt to start the engine. The display content alternates between the
loading
The voltage drop is the result of the evaluation of the starter system and the
measured voltage drop.
Put the battery back into operation.
Fully charge the battery and put it back into
operation
take.
Fully charge the battery and repeat the test. If the
battery is not fully charged before the test, the
test results may be falsified. If the message
CHARGE & CHECK is displayed again after fully
charging, replace the battery.
Replace battery and test again. The message
REPLACE BATT. REPLACE BATTERY may also
be displayed if the contact between the battery
cables and the battery is poor. Before actually
replacing the battery, disconnect the battery
cables and test the battery again with the option
NOT IN DRIVE.
Replace battery.
9
-
-
Meaning
Werbung
