Deleting Transmitters - Becker R8/17Psf Bedienungsanleitung

Operating Instructions
11a)
Clack
Clack
Clack Clack -
11b)
Clack
Clack
Clack Clack -
12a)
Mains connection
blue
N
black
L1
green/yellow
PE
Clack Clack -

11) Deleting transmitters

11a) Deleting transmitters individually
Note
The master transmitter which was programmed in the drive according to
Point (3) cannot be deleted. It can only be overwritten (see Point 12).
Press the programming button on the mas-
ter transmitter for 3 seconds.
Now press the programming button of the
transmitter to be deleted for 3 seconds.
Then press the programming button of the
transmitter to be deleted once again for 10
seconds.
11b) Deleting all transmitters (except master transmitter)
Press the programming button on the mas-
ter transmitter for 3 seconds.
Now press the programming button on the
master transmitter once again for 3 sec-
onds.
Now press the programming button on the
master transmitter once again for 10 sec-
onds.
12) Overwriting master transmitter
There are two ways of overwriting the master transmitter:
a) Put tubular drive into programming mode by switching on power supply
b) Put tubular drive into programming mode using radio switch
12a) Putting tubular drive into programming mode by switching on power supply
Motor cable
blue
Switch off the power supply to the tubular
drive and reconnect after 5 seconds.
black
brown
Note
To ensure that the new master transmitter is programmed in the desired
green/yellow
tubular drive only, the programming mode for all other tubular drives which
are connected to the same power supply must be deactivated. To do so,
after the power supply has been switched back on, execute a command
control (adjust or stop) with the transmitter of these tubular drives or move
the radio switch from the inner to the outer position. If the radio switch is
already in this position, slide the switch to the inner position and back to
the outer position again.
Now press the programming button of the
new master transmitter for 10 seconds.
Action
The tubular drive makes a „clack" sound to
confirm.
The tubular drive makes a „clack" sound to
confirm.
The tubular drive makes a „clack-clack"
sound to confirm.
The transmitter has been deleted from the
tubular drive.
The tubular drive makes a „clack" sound to
confirm.
The tubular drive makes a „clack" sound to
confirm.
The tubular drive makes a „clack-clack"
sound to confirm.
All transmitters (except master transmitter)
have been deleted from the receiver.
The tubular drive goes into programming
mode for 3 minutes.
The tubular drive makes a „clack-clack"
sound to confirm.
The new master transmitter has been pro-
grammed in and the old deleted.
25
Response