Setting The End Limits - Becker R8/17Psf Bedienungsanleitung

Operating Instructions
5) There are two ways to set the end limits:
a) Extend curtain/canopy to desired position and retract to desired position with no end stop
b) Extend curtain/canopy to desired position and retract to end stop
Note
The end limits can only be set using the master transmitter. The rotation setting must be correct. When end limits are being
set, the tubular drive remains in maintained command mode. The lower end limit must always be programmed first.
If, during extension or retraction, the tubular drive stops due to an obstruction, it is possible to extend or retract the curtain/
canopy as necessary in order to move it away from the obstruction. The obstruction can then be removed and the curtain/
canopy adjusted into the desired end limit position.
5a)
Clack
Clack
5b)
Clack

Setting the end limits

Action
5a) Lower end limit to upper end limit with no end stop
Note
With this end limit setting there is no automatic curtain/canopy length
adjustment.
Move the curtain/canopy to the desired
lower end limit.
First press the programming button and,
within 3 seconds, also press the EXTEND
button and keep both buttons pressed.
Then move to the desired upper end limit.
Now press the programming button and,
within 3 seconds, the RETRACT button and
keep both buttons pressed.
5b) Lower end limit to end stop
Move the curtain/canopy into the desired
lower end limit.
First press the programming button and,
within 3 seconds, also press the EXTEND
button and keep both buttons pressed.
Then move to the fixed end stop.
21
Response
The tubular drive makes a „clack" sound to
confirm.
The tubular drive makes a „clack" sound to
confirm.
The end limits are set.
The tubular drive makes a „clack" sound to
confirm.
The tubular drive switches off automati-
cally.
The end limits are set.