Becker R8/17PSF Bedienungsanleitung Seite 20

RETRACT button
STOP button
EXTEND button
Learn button
1) +2a)
Mains connection
blue
N
black
L1
green/yellow
PE
2b)
3)
Clack-Clack
4)
Rotation switch
Radio switch
Radio switch
Rotation switch
1) Connecting the tubular drive
Connect the tubular drive to the power supply.
2) Activating programming mode for tubular drive
Motor cable
blue
2a) Activating programming mode for tubular drive by switching on power supply
Now switch on the power supply. The tubular drive will be in programming mode for 3
black
minutes.
brown
Note
If several tubular drives are to be operated in parallel, the programming
green/yellow
mode for one tubular drive can be deactivated by sliding the radio switch
into the outer position after the power has been switched on.
If the radio switch is already in this position, slide the switch back inwards
and back to the outer position again.
2b) Activating programming mode for tubular drive using the radio switch
Slide the radio switch into the inner posi-
tion. If the radio switch is already in this
position, slide the switch outwards and back
to the inner position again.
3) Programming the master transmitter
Note
Follow the instructions given in the operating manual for the transmitter.
If a transmitter has already been programmed into the receiver, press and
hold the programming button for 10 seconds.
Press the programming button for 3 sec-
onds when the programming mode is acti-
vated.
4) Checking the rotation setting
Press the RETRACT or EXTEND button.
If the curtain moves in the wrong direction, the rotation setting must be changed.
Proceed as follows to do so:
Slide the rotation switch into the opposite
position.
Action
The tubular drive goes into programming
mode for 3 minutes.
The tubular drive makes a „clack-clack"
sound to confirm.
The programming process is complete.
The curtain moves in the desired direction.
=> The rotation setting is OK.
The rotation setting has been changed.
Recheck the rotation setting.
20
Operating Instructions
Response