Werbung
Verfügbare Sprachen
Verfügbare Sprachen
(2) Cieaning the tape transport system
Moisten gauze with ethyl alcohol and use it
to wipe the surfaces of components which come
into contact with the tape.
Caution: Be careful that the tape transport
components are not damaged nor deformed
by cleaning.
5-2, Lubricating Sonic Slidas Oi! (#1600)
(1) Periodic lubrication
Lubricate the specified locations only when
replacing components,
Normally,
it is not necessary to lubricate
in
a period other than components are replaced.
(2) Procedure
Use the oiler to apply one or two drop of
Sonic Slidas oil to the specified sections.
Refer to the exploded views for the
lubricating locations.
Caution: Do not use too much oil because it may
spill over or leak,
coming into contact
with rotating parts and causing slippage
or other defects,
If too much oil is applied,
wipe clean
using gauze moistened with ethyl alcohol.
5-3. Greasing the Froil (G31-SAY)
(1) Periodic greasing
Grease the specified locations only when
replacing components,
Normally,
it is not necessary to grease
in a
period other than components are replaced,
(2) Procedure
Apply Froil with a stick or brush to the
specified locations.
Refer to the exploded
views for the greasing locations.
Caution:
Do not use excess Froil,
It may come
into contact with the tape transport
components and may cause defects.
Wipe off any excess using gauze
moistened with ethyl alcohol,
E3-3
Werbung
