Hitachi VM-H38E Wartungsanleitung Seite 37

4-3-4, Take-up guide roller base <TGB>,
take-up slant pole <TSP>,
guide roller base plate <GBP>,
centre gear <CG>, pulley gear <PG> and
capstan belt <CB> (Fig. 4-11)
"Components to remove in advance:
Subchassis plate <SCP>, take-up
disk <TRD>, idler gear <IG@, subchassis
holder <SCH>, subchassis assembly <SCA>
® Guide roller rail <GRR>, capstan motor 4-3-3
<CPM>, take-up guide roller <TGR>
(1) Take-up guide roller base <TGB> and
take-up slant pole <TSP>
1) Remove one (1) washer.
2) Remove one (1) washer.
3) Remove the TGB and TSP in the direction of
the arrow, moving them along the groove in
the GBP.
MAIN CHASSIS
Fig. 4-11
(2) Guide roller base plate <GBP>
Caution: Remove TGB and TSP in advance before
removing GBP.
1) Remove three (3) screws.
(3) Centre gear <CG>, pulley gear <PG> and
capstan belt <CB>
1) Remove one (1) washer.
2) Remove CG and PG together with CB.
1. TAKE-UP GUIDE ROLLER BASE (TGB)
2. GUIDE
BASE PLATE (GBP)
3. CAPSTAN BELT (CB)
E2-25