Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3-1-3.
Operation switch unit <OSW,
front case <FC>,
microphone <MIC>,
IR/LED circuit
board <IR/LED CBA>,
main circuit
board
<MAN CBAD,
tape transport
mechanism <TTMD,
camera block <CAM>,
control
unit <CON> and
left case <LC> (Fig. 3-3)
Components
to remove
in advance'
;
¢ Cassette
lid <CSL>,
opening right case
3-1-1
¢ Top cover <TPC>
3-1-2
Caution:
Remove
the CSL and TPC only when
removing the TTM
(1) Operation switch unit <OSW>
1)
Remove the OSW in the direction of the arrow.
(The OSW and MAN CBA are connected via an in-
board connector. )
(2) Front case <FC> and microphone <MIC>
1)
Remove one
(1) screw.
2)
Remove the FC in the direction of the arrow.
3)
Disconnect
one
(1) connector.
4)
Release one
(1) tab.
5)
Remove
the MIC
in the direction
of the arrow.
(3)
IR/LED circuit
board <IR/LED CBA>
Caution:
Remove
the FC from the LC in advance
before
removing the IR/LED CBA.
1)
Remove the IR/LED CBA in the direction of the
arrow.
(The IR/LED CBA and MAN CBA are
connected via an in-board. connector. )
5. TAPE TRANSPORT
MECHANISM (TTM)
7, LEFT CASE (LC)
1. OPERATION SWITCH UNIT
(OSW)
Fig. 3-3
Items
(4)
Main circuit board <MAN CBA>
Caution:
Remove the OSW, FC and IR/LED CBA in
6)
(5)
advance before removing the MAN CBA,
Release two (2) tabs.
Disconnect
three
(3) flat cables.
Remove one (1) screw.
Release two (2) tabs.
Open the MAN CBA in the direction of the arrow.
(MAN CBA and the process circuit board are
connected via an in-board connector. )
Disconnect
two (2) flat cables and one
(1)
connector.
Tape transport
mechanism
<TTN>
Caution:
pee
the OSW, FC, IR/LED CBA and MAN
1)
2)
(6)
1)
2)
3)
(7)
A in advance before
removing the TTM.
Remove three
(3) screws.
Remove
the TTM in the direction
of the arrow.
Camera block <CAM>
Remove four (4) screws.
Remove the CAM in the direction of the arrow.
Disconnect
one
(1) flat cable on the
autofocus circuit board.
Control
unit <CON> and left case <LC>
Caution:
Remove the OSW, FC, IR/LED CBA and MAN
CBA in advance before removing the CON
and
L C .
1) Remove
two (2) screws.
E2-13
Werbung
