Parkside PWD 20 B2 Originalbetriebsanleitung Seite 27

Troubleshooting
Problem
Appliance does not
start
Weak or no suction
power/throughput
Float does not switch
the appliance off
Dust or dirt is blow out
of the device
Possible cause
No mains power supply
On/off switch (
broken
Worn out carbon brushes
Defective motor
Suction hose (
13) or
nozzle (
18/20) clogged
Suction tube (
12) not
correctly assembled
Dirt container (
Dirt container (
Filter (
15/16/17) full or
clogged
Float in fi lter basket (
in incorrect position (e. g.
due to jerky movements)
Float in fi lter basket (
defective
Float in fi lter basket (
not moving
Float in fi lter basket (
defective
Filter (
15/16/17) is not
or not correctly assembled
Fault correction
Check the socket, mains con-
nection cable, line, plug and
fuse and have them repaired
by a qualifi ed electrician if
necessary
3) is
Repair by Customer Care
Removing obstructions and
blockages
Assemble the suction tube
properly
Close the dirt container
6) open
6) full Empty the dirt container
Empty, clean or replace the
fi lter
Turn off the appliance, the
21)
ball will sink, then switch the
appliance back on
21)
Repair by Customer Care
21)
Release fl oat
21)
Repair by Customer Care
• Check the correct position
of the fi lter
• Insert missing fi lter
GB
27