Pioneer CT-X500 Bedienungsanleitung Seite 3

REAR PANEL FACILITIES AND CONNECTIONS
e Read through the operating instructions of the stereo
components you plan to connect with this unit.
e Set the stereo amplifier's power switch to OFF and its
volume control to the minimum position.
e Do not switch on the power until all the connections have
been completed.
Stereo amplifier
e The top jacks are for the left (L) channel; the bottom jacks
are for the right (R) channel.
e Make certain the connectors are pushed all the way in.
An improper connection or poor contact will result in no
sound, or will degrade the sound.
Ca
I? 2 SA
1 L ©
©)
|
G
R ©
Recordingįconnection
Playback connection
—— Wall socket
ENGL
J
sl
© INPUT LEVEL volume
When the unit is used in combination with the separately
purchased Pioneer stereo amplifier A-X700, stereo tuner
F-X700, FX-500, etc., the volume knob should be set in the
center click position (W). In this position, volume will be ad-
justed to optimum levels.
When the unit is used with other stereo components, the
volume levels may need fine adjustment. In this case, if
the volume is too low and noise is heard, turn the volume
control knob to the right ( (> ). If the volume is too loud
and sound is distorted, turn the control knob to the left
(NM).
@ LINE INPUT (REC) terminal
Signals to be recorded are received here. The accessory
pin-plug cords should be connected between these ter-
minals and the stereo amplifier's TAPE 1 REC (REC @) ter-
minals.
© LINE OUTPUT (PLAY) terminal
Playback signals are transmitted from here to the stereo
amplifier. The accessory pin-plug cords should be con-
nected between these terminals and the stereo amplifier's
TAPE 1 PLAY (PLAY ©) terminals.
© AUTO FUNCTION TAPE terminal
When the unit is used in combination with Pioneer's
A-X900 or A-X700 stereo amplifier, the mini plug is con-
nected to the TAPE 1 AUTO FUNCTION terminal. Connec-
tion is not necessary when the unit is used in combination
with any amplifier other than the two models mentioned
above.
@ REMOTE CONTROL terminal
G Power cord
Plug the power cord into the AC OUTLET on the rear panel
of the amplifier or into an AC wall socket.
@ LINE VOLTAGE SELECTOR
(D and D/G models only)
Check that the correct voltage is selected.