Pioneer CT-X500 Bedienungsanleitung

Operating Instructions
Bedienungsanleitung
Mode d'emploi
Istruzioni per l'uso
English; Page 1
Deutsch; Seite 16
Francais; Page 31
Italiano; Pag. 46
Thank you for buying this Pioneer product.
Please read these operating instructions thoroughly, so you
will know how to operate your model properly. After you
have finished reading the instructions, put them away in a
safe place for future reference.
For the sake of convenience, these operating instructions are
based on the model HEM, and they can be used for the HB,
HP, KU, KC, D and D/G models.
The differences between the models are given below.
HEM model:
For Europe excluding U.K. ('HEM' stamped on packing
case): Power line voltage is AC 220 volts.
HB model:
For U.K. ('HB' stamped on packing case): Power line voltage
is AC 240 volts.
HP model:
For Australia ('HP' stamped on packing case): Power line
voltage is AC 240 volts.
KU and KC models:
For U.S.A. and Canada ('KU' or 'KC' stamped on packing
case): Power line voltage is AC 120 volts.
D and D/G models:
For destinations excluding above ('D' or 'D/G' stamped on
packing case): A 3-point (120 V/220 V/240 V) voltage selec-
tor switch is provided.
NOTE: =
| Depending upon the model, the design of the power plug
and the power outlet differs.
The line voltage selector switch is located on the rear
panel of the unit. Please check that it is set properly
before plugging the power cord into an outlet. If it is not
set properly, change the setting according to the LINE
VOLTAGE SELECTION (DandD/G models only).
"This product is manufactured to comply with the radio in-
terference requirements of EEC Directive 76/889/EEC and
82/499/EEC."
STEREO CASSETTE TEPE DECK
STEREO KASSETTEN BANDGERAT
MAGNETOPHONE A CASSETTE STEREO
REGISTRARORE STERO A CASSETTE
T-X500
IMPORTANT NOTICE (For KU and KC
models)
The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed war-
ranty card and keep in a secure place. This is for your securi-
ty.
WARNING: TO PREVENT FIRE
OR SHOCK HAZARD, DO NOT
EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
LINE VOLTAGE SELECTION
(D and D/G models only)
Before your model is shipped from the factory, the switch is
set to the power requirements of the destination; never-
theless, you should check that it is set properly before plug-
ging the power cord into the AC outlet.
1. Disconnect the power cord.
2. Provide yourself with a medium size screwdriver.
3. Insert the screwdriver into the groove on the voltage
selector and adjust to the voltage value of your area.
©
=
=
—
£
Screwdriver
HEM (for Europe excluding U.K.), HB (for U.K.), HP (for
Australia), KU (for U.S.A.) and KC (for Canada) models
are not provided with a LINE VOLTAGE SELECTOR
switch.
WPIONEER'