Bartscher PI100-98ET Bedienungsanleitung Seite 38

−
Now proceed to light the appliance as directed in the instructions for use.
−
While the appliance is in use, voltage should not differ from the nominal voltage more than +/- 10%.
−
The test report must be completed in full and submitted to the customer who should then sign in
acceptance. With effect from this moment, the appliance is covered by the manufacturer's warranty.
Warning! : All maintenance operations shall only be performed by a technically qualified service
centre!
−
To ensure correct and safe operation, the appliance must be inspected and serviced at least once a year
only. Maintenance includes also controlling the components and tear of pipes, feeding pipes, electrical
components etc.
−
It is advisable to replace worn components during maintenance operations to avoid the need for other
maintenance calls and unexpected failures.
−
It is also advisable to apply for a maintenance contract with the customer.
Warning! : Only technically qualified service centres can perform the operations described
below!
Warning! : Before resetting the safety thermostat, it is always necessary to eliminate the
problem causing its activation!
Problem and possible cause
The content of the vat does not heat up:
−
the safety thermostat has been
activated;
−
the heating elements have a failure;
−
selector/switch failure.
−
This manual contains all the instructions required for a proper and safe use of our appliances.
Keep the manual in a safe place for future consultation!
−
This appliance is for catering use, hence they must be used only by trained kitchen staff.
−
The appliance must always be kept under control during use.
Warning! : The manufacturer shall not be held responsible for injuries or damage due to the non-
compliance with safety rules or an improper use of the appliance by the operator.
−
Some improper operating conditions may even be caused by an improper use of the appliance, therefore
it is important to train personnel properly.
−
All the installation and maintenance operations must be performed by fitters who are members of
an official register.
−
Respect the periods required for maintenance. With this is mind, customers are recommended to sign a
service agreement.
Manuale d'istruzione per l'installazione, la manutenzione e l'uso
Pentole elettriche Serie 900
2.4. MAINTENANCE OF THE APPLIANCE
2.4.1. POSSIBLE FAILURES AND THEIR ELIMINATION
Access to components and operation
Safety thermostat
The safety thermostat can be reached once the lower front
panel has been removed.
Heating elements
The heating elements can be reached once the lower front
panel has been removed.
Selector switch-Operating thermostat
To reach remove the upper front panel.
3.1. WARNINGS AND HINTS FOR USER
pagina
06.10.02
- IT
38