Bosch MUM59 Serie Gebrauchsanleitung Seite 28

en Operation
Reversible shredding disc –
coarse / fine
for shredding food coarsely or finely, e.g.
fruit, vegetables or cheese as Gouda or
Edam.
Marking:
■ 2 = coarse side
■ 4 = fine side
Note: Not suitable for processing nuts or
hard cheese, e.g. Parmesan.
Tip: Shred soft cheese with the coarse side
only.
Fine grating disc
for shredding food finely, e.g. nuts
or hard cheese such as Parmesan.
Note: Not suitable for processing soft
cheese and cheese slices.
Reversible slicing / shredding
disc
for grating raw potatoes or cutting into
slices.
Note: Not suitable for processing very
fibrous foods, e.g. leek or mango.
Working with the continuous-feed
shredder
Figure G:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti­clockwise until it locks
into place.
■ Press the Release button and
move the swivel arm to
position 3.
■ Remove drive cover from the
drive of the continuous­feed shredder
(Figure G-5a).
■ Hold disc holder at the lower end,
ensuring that the two tips are face up.
■ Carefully place the required slicing or
shredding disc onto the tips of the disc
holder (Figure G-6a). In the case of
reversible discs, ensure that the required
side is face up.
■ Grip disc holder at the upper end and
insert into the housing (Figure G-6b).
28
■ Attach the cover (note mark) and turn all
the way in a clockwise direction.
■ Place continuous­feed shredder on the
drive and rotate all the way in a clockwise
direction, as illustrated in Figure G-8.
■ Turn rotary switch to recommended
setting.
■ Put food to be processed in the feed tube
and push down with the pusher.
W Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip: To ensure even cutting results, process
thin ingredients in bunches.
Note: If the food to be processed sticks in
the continuous­feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove
cover from the continuous­feed shredder
and empty feed tube.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the continuous­feed shredder in
an anti­clockwise direction and remove.
■ Rotate the lid in an anti­clockwise
direction and remove.
■ Remove disc holder with disc. To do this,
press finger from below against the drive
shaft (Figure H).
■ Clean parts.
Blender
Observe the application examples in
table N
W Risk of injury from sharp blades /
rotating drive!
Never place fingers in the attached blender!
Do not remove / attach the blender until
the drive is at a standstill! Operate the
assembled blender only and with the lid
attached. Do not operate blender when
empty.
W Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid.
Printed on 100% recycled paper