Werbung
3) To make the gear engagements
on the left and right even, turn
the shaft forward until four to five clicks are heard from the left
and
right gears.
(The moving
panel and
plastic belt will warp
slightly at this time.)
4) Turn over the front cover.
Turn the shaft in the direction of the
arrow to move
the plastic belt to a position where the end of
belt does not come
out of the front cover.
If the plastic belt comes
out of the front cover, the belt will
be caught by the main unit when
the front cover is to be
attached to the indoor unit.
—
5] Attach the front cover
to the indoor unit.
1
~~
After fitting the front cover
into the main unit from the bottom,
securely engage
the hooks
(at 5 points) at the top so that no
lead wires are caught.
Then push the center of cover against
the indoor unit in the direction of the arrow to secure it.
2) Tighten the screw at the bottom of the front cover to attach the
screw cover.
3) Connect the connector, replace the cover and tighten the screw.
© Attach the front grille.
1) Securely insert the projections of the left and right arms on the
top of the front grille into the holes in the main unit.
Hooks
2) Attach the honeycomb net and filter so that the honeycomb net
(at 4 points)
faces forward.
3
—
Press the two sections indicated "PUSH" on the left and right of
the front grille, and also the center, to attach the panel.
@
Perform operation check.
1
~—_
Press the AUTO
SWING
(filter) button on the remote contro! to
move
the moving
panel;
make
sure that it opens
and closes
normally.
— 88 —
Werbung
