Webasto Cool Top Trail 35 Bedienungsanleitung Seite 20

5.13 Sleep function
SLEEP
Fig. 37: Setting the sleep function
5.14 Units of temperature change
°C/°F
Fig. 38: Celsius / Fahrenheit changeover
5.15 Reset of the remote control
Fig. 39: Reset of the remote control
Cool Top Trail 35
The sleep function automatically modifies the target tempera-
ture value to provide a pleasant sleeping temperature. It also
helps to reduce compressor run time and thus energy con-
sumption as well as noise levels.
Press the
X
– The
up to indicate that the sleep function is activated.
– In COOL mode the set temperature will automatically
increase in two steps and it will have inceased by 2°C after
two hours.
– In HEAT mode the set temperature will automatically
decrease in three steps and it will have decreased by 3°C
after two hours.
– The sleep function is only available in COOL or HEAT
mode.
Press the
X
Press the
X
temperature display: Celsius or Fahrenheit.
– You can do this in any mode.
– The display on the air distributor follows the selection
°C/°F
made on the remote control.
To reset the remote control to factory settings take out the
X
batteries and put them back in.
– The clock will have to be set again.
– The timer is deactivated.
key to activate the sleep function.
SLEEP
symbol in the display of the remote control shows
key again to deactivate the sleep function.
SLEEP
key to select the temperature units of the
°C/°F
20