Webasto Cool Top Trail 35 Bedienungsanleitung Seite 10

400 x 400
Fig. 09: Sealant paths
Fig. 10: Forming an effective seal
4.7 Installation of the outdoor unit
Fig. 11: Position the outdoor unit
Cool Top Trail 35
Turn the part over and on the reverse side of "This
X
side up", apply silicone sealant uniformly over the
path shown.
360 x 360
Turn the part over again and make sure "This side
X
up" is up. Press down firmly over the installation
hole and remove any sealant that has squeezed out.
Put the outdoor unit over the installed adaptor
X
frame and adjust the position to make sure the four
bolt holes on the corners align.
NOTE
The outdoor unit is heavy. Always have a
second person to help carrying the unit.
Do not lift the outdoor unit by the upper
white cover. Lift it by the bottom base.
Check with the M8 bolts if the holes of the
outdoor unit are aligned with the holes of
the adaptor. If not then reposition the out-
door unit to align the holes.
Do not apply additional sealant between
the outdoor unit and the adaptor frame.
10