Webasto Cool Top Trail 35 Bedienungsanleitung Seite 11

4.8 Installation of the air outlet duct
Fig. 12: Installation of the air outlet duct
1. Air outlet duct
2. This face down
3. Flat head screw
4.9 Connecting the power supply
Fig. 13: Location of the terminal block
Cool Top Trail 35
1
2
3
1
NOTE
This step can be done before installing the
outdoor unit, but special care has to be tak-
en not to damage the outlet air duct.
Cut the 4 cable ties that hold the outlet air duct (1)
X
compressed.
Fix the air outlet duct to the outdoor unit from in-
X
side using 4 flat head screws.
NOTE
Make sure you mount the duct with the
correct face down (2).
Look upward from inside the vehicle, and locate the
X
terminal block (1).
Connect the power supply cable to the 3-pole termi-
X
nal block.
NOTE
Match the corresponding active, neutral
and the ground wire. Firmly tighten up the
screws to make sure the power line is not
loose or improperly connected, otherwise a
short circuit or fire could be caused.
11