Replacing Parts - Angelo Po 1G1FAPG Bedien- Und Installationshandbuch

GREASING THE GAS TAP
To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Pull off the knob (A).
3 - Undo the screws (B)
and remove the control
panel (C).
4 - Undo the screws (D)
and extract the cap (E).
5 - Pull off the cone (F).
6 - Clean the cone (F) and
its seat.
7 - Coat the cone
grease (F), fit it in its seat
and turn it a few times.
8 - Pull off the cone (F) to
remove the excess
grease.
9 - Replace the cone (F),
the cap (E), the control
panel (C) and the knob (A).
RECOMMENDATIONS FOR REPLACING PARTS
Before carrying out any replacement procedure, ac-
tivate all the safety devices provided and decide
whether staff at work and those in the vicinity
should be informed. In particular, turn off the gas
supply tap and prevent access to all devices which
might cause unexpected health and safety hazards
if turned on.
If work parts have to be replaced, use original spare
with

REPLACING PARTS

C
A
parts only.
The manufacturer declines all responsibly for injury
or damage to components due to the use of non
original parts, or extraordinary work on the appli-
ance which may modify the safety requirements
without the manufacturer's authorisation.
When ordering components, follow the instructions
provided in the parts catalogue.
- 19 -
E
F
B
D
IDM-39609301400.tif
English
IT
9
GB
DE
FR
ES