Analog Rocking/Waving Shaker Control Panel; Analog Rocking/Waving Shaker Operating Instructions; Operating Tips - OHAUS SHRK07AL1 Bedienungsanleitung

ANALOG ROCKING/WAVING SHAKER CONTROL PANEL

The front panel of the Analog Rocker contains all the controls and displays needed
to operate the unit.
speed adjust
knob
5
1.800.561.8187
tllt adjust time adjust rocker
knob knob switch
www.
ANALOG ROCKING/WAVING SHAKER OPERATING
INSTRUCTIONS
1. Getting ready:
a. Rocker switch should be in the center Standby position.
b. Plug the power cord into a properly grounded outlet. Manually move the tray to a near
horizontal "home" position before powering the unit.
c. Position Speed and Tilt knobs between 2 and 3 on the dial.
d. Push rocker switch to the "I" On position. The rocker will automatically level and begin
running at a moderate speed and tilt.
2. Setting speed and tilt:
a. Turn Speed and Tilt knobs to achieve the desired settings.
3. Setting time:
a. To run in timed mode, set timer, speed, and
desired settings.
b. Press the rocker switch down to the Time position and release.
c. The unit will now run for the set time.
d. To exit the Time mode, press the rocker switch up and return it to the center
Standby position.
NOTE: After the timer is set, any time adjustments will not take affect. To reset time,
exit Time mode (see step 3d above) and enter new time following the steps above.

OPERATING TIPS:

Centering your sample and even weight distribution on the tray helps balance and
stability.
information@itm.com
.com
EN
tilt knobs to the