Lid Control; Lid Open - OHAUS Frontier FC5513 Bedienungsanleitung

TM
Frontier Centrifuge FC5513
ATTENTION:
After turning on the power switch, open the centrifuge lid first, before starting the centrifuge.
3.2

Lid control

3.2.1

Lid open

Before the run, when the lid of the centrifuge is closed, the word "close" (M1) appears in the display "RPM | RCF"
(A-1). Additionally, if there is a rotor in the centrifuge, the word "rotor"(M3) appears as well as the code number of
the respective rotor, which is in the centrifuge system "71" (M4). If there is no rotor in the centrifuge, the word "rotor"
(M3) flashes and additionally the word "no" (M4) appears. By pressing the key "Stop/Lid" (9) you can release the
lid of the centrifuge. As soon as the lid is completely released, the word "open" (M2) appears. Now you can open
the lid of the centrifuge.
Please refer to figure 15 below for reference.
During the run you can call up the rotor type at any time by pressing the key "Stop/Lid" (9).
Figure. 14: Power Switch
M2
A-1
M3
M4 M1
Figure. 15
4
9
EN-7