Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Disinfection
Please carefully observe the points below when
disinfecting your atomiser and the atomiser set.
We recommend disinfecting the individual parts
on a daily basis after the last usage as a minimum
measure.
• First, clean the atomiser and atomiser set as
described in the "Cleaning" section.
• Place the disassembled atomiser
sal douche
, mouthpiece
19
masks
and the disassembled nose-
14 15
piece
in boiling water for 5 minutes. Con-
16
tact between the parts and the hot base of the
pan should be avoided.
• For disinfection immerse the compressed air
hose in a 2 % sodium hypochlorite (NaOCl)
solution for 15 minutes (i.e. a solution made
from the disinfecting agent Amuchina® or a
2 % sodium hypochlorite solution mixed by
your pharmacist). Afterwards rinse all parts
thoroughly with tap water, to fully remove any
possible residue of the disinfectant solution.
Important
Do not boil or autoclave the compressed air hose.
• Put the parts together again when they are
completely dry and place them in a dry, sealed
container.
Notice
Ensure that the parts are completely dried after
cleaning, otherwise the risk of bacterial growth is
increased.
Drying
• Place the individual parts on a clean, dry and
absorbent surface and leave them to dry com-
pletely (at least 4 hours).
Durability of materials
• As with any plastic parts, atomisers and the
rest of the atomiser set are affected by a cer-
tain amount of wear and tear when used and
hygienically prepared on a frequent basis. Over
time, this can lead to a change in the aerosol,
which can have a negative effect on the effi-
ciency of the treatment. We therefore advise
you to replace the atomiser and the atomiser
set no later than one year if the parts are not
disinfected more than 360 times a year. Fre-
quent disinfection shortens the service life of
the parts.
• The following point should be observed when
selecting the cleaning product or disinfectant:
Storage
• Do not store in damp conditions (such as in a
• When storing and transporting, protect from
, na-
9
, the silicone
13
• The parts of the atomiser set can be securely
10. ATOMISER SET AND RE-
PLACEMENT PARTS
The atomiser set parts and replacement parts are
available from the corresponding service address
(according to the service address list). Please state
the corresponding order number.
Designation
Atomiser set = year pack
includes:
Mouthpiece
Nosepiece
Silicone adult mask
Silicone children's mask
Atomiser
Compressed air hose
Filter
Angled fitting
Nasal douche
If the device is not used according to the specifica-
tions, perfect functionality cannot be guaranteed!
We reserve the right to make technical changes to
improve and develop the product. This device and
its atomiser set conform with the European stand-
ard EN 60601-1-2 (Group 1, class B, in accordance
with CISPR 11, IEC 61000-3-2, IEC 61000-3-3,
IEC 61000-4-2, IEC 61000-4-3, IEC 61000-4-4,
IEC 61000-4-5, IEC 61000-4-6, IEC 61000-4-7,
IEC 61000-4-8, IEC 61000-4-11) and is subject to
particular precautions with regard to electromag-
netic compatibility.
Please note that portable and mobile HF commu-
nication systems may interfere with this device.
For more details, please contact our Customer
Services at the address indicated.
24
Only use a mild cleaning product or disinfect-
ant in the concentration and volume prescribed
by the manufacturer.
bathroom) and do not transport with any damp
items.
prolonged direct sunlight.
stored in the storage compartment
the device in a dry place, ideally in the original
packaging.
Notice
. Store
4
Material
REF
603.76
PP/silicone
PP/silicone
Silicone/PP
Silicone/PP
PP/silicone
PVC
PU
PP
PP
601.37
Werbung
