Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
screwdriver
•
electric drill, 3 mm / 0.12" carbide drill bit
•
mounting screws
•
power wire min. 1 mm² / 17 AWG
•
ground wire min 1 mm² / 17 AWG
•
Disconnect vehicle battery before starting the installation! (Note the vehicle's operating manual)
•
Never drill any holes into the fuel tank, brake pipes, wiring or any other sensitive parts of the vehicle!
•
Keep the installed wires away from any sharp edges!
High powered audio systems in a vehicle are capable of generating "Live Concert" levels of sound pressure. Continued exposure to
excessively high volume sound levels may cause hearing loss or damage. Also, operation of a motor vehicle while listening to audio
equipment at high volume levels may impair your ability to hear external sounds such as horns, warning signals or emergency vehicles!
This may lead to potential traffic hazards. In the interest of safety, consumer electronics recommends listening at lower volume levels
while driving.
Before starting to install the unit, please consider the following:
a. If you are planning to expand your system by adding other components in the future, ensure enough space is left
and cooling requirements are met.
b. If your head-unit is equipped with pre-amplified outputs (RCA), we recommend to use them.
a)
Select a suitable location that is convenient for mounting, is accessible for wiring
and has enough space for air circulation and cooling.
b)
You may use the unit as a template to mark the mounting holes, then remove it and drill the marked holes.
Finally mount the unit with the mounting screws.
Choose a mounting position where all electric wires are protected from damage by sharp edges, heat or other conditions. +12 Volt DC
electrical connections must be fused on the battery side. Make sure your head-unit and all other devices will remain turned off while
connecting parts of the system. If it is necessary to replace any fuse make sure to use only an equivalent one. Using inferior fuses may cause
serious damage to your unit, system or even your cars wiring. Any kind of damage traced back on disregard of these notes will not be
covered by the warranty!
Required parts and tools for the installation
Most important
Planning your system
Mounting the Unit
WARNING!
Caution
- 3 -
Werbung
Inhaltsverzeichnis
