Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
MT
7. If necessary, repeat steps 5 and
6 until both edges are sharp.
a
a
118°
b
angle to the drill axis (b) and
must be the same length so that
the drill runs centrically.
8. Move the On/Off switch (6) to
position "O" to switch the tool
off. The device turns off.
Replacing the grindstone
Information
on replacement
• Ensure that the grindstone di-
mensions match those of the
device.
• Never use separate bushings or
adapters in order to make grind-
stones with a hole that is too
large fi t the device.
• Do not use any saw blades.
• Reassemble the device complete-
ly after replacing the grindstone.
• Replace the grindstone when it
is worn, damaged or broken, or
if grinding performance decrea-
ses or is irregular.
62
The angle bet-
ween the two
cutting edges (a)
should be 118°.
Both cutting
edges (a) must
have the same
Switch off the device and
unplug the mains plug.
Allow the device to cool down.
When loosening and tighte-
ning the nuts (
8) must be held fi rm
grindstone (
by hand.
See illustration
1. Unscrew the 4 screws (3) on the
cover (4).
2. Lift the cover (4) up and off.
See illustration
3. Turn the nut (9) counter-clockwi-
se
using an open-end wrench
(27 mm) to loosen it.
4. Remove the nut (9) and the disc
(10).
5. Remove the grindstone (8).
6. Place a new grindstone (8) on
the mount (11).
7. Fix the new grindstone (8) in the
reverse order with the disc (10)
and nut (9).
The fl at side of the grinds-
tone (8) must be in contact
with the mount (11).
Tighten the nut (9) in the clock-
wise direction
The spring (12) must be in the
position indicated in Fig.
If the grindstone (8) is not in the
correct position, the cover (4)
cannot be closed
9), the
:
:
.
.
Werbung
