Installation And Connection; Mysentio Wifi Installation - Sentiotec MySentio WiFi Montage- Und Gebrauchsanweisungen

Instructions for installation and use

4. Installation and connection

Work may only be carried out when the power has been disconnected.
During installation, observe the technical data on page 20.
ATTENTION!
Interference can impair signal transmission
● Route all data cables separately from other mains cables and control cables.
● Protect cables with only one layer of insulation by using a conduit (double
insulation).
1. Secure the WiFi module 1 somewhere near the sauna control unit and within
the range of its network (WiFi) using the screws provided.
2. Sentiotec WiFi is connected to the sauna control unit using the 8-pin Ethernet
cable in accordance with the following diagrams:
3. Make a note of the serial numbers (10 digits) of your devices to ensure you
can enter them in the app later on.
Sauna heater ................................................................................................
Sauna control unit ........................................................................................
Other products ..............................................................................................
ATTENTION!
Damage to the device!
Installation of the app and input of the settings (see "6. Overview of functions" and
"7. Operation") must be completed before the sauna control unit is switched on.

4.1. MySentio WiFi installation

27.5
p. 6/20