Installation And Connection - Sentiotec MySentio WiFi Bedienungsanleitung

Installation and operating instructions

4. Installation and connection

Work may only be carried out when the power has been disconnected.
During installation, observe the technical data on Page 8.
ATTENTION!
Interference can impair signal transmission
● Route all data cables separately from other mains cables and control cables.
● Protect cables with only one layer of insulation by using a conduit (double
insulation).
1. Secure the WiFi module somewhere near the sauna control unit and within
the range of its network (WiFi) using the screws provided.
2. Sentiotec WiFi is connected to the sauna control unit using the 8-pin Ethernet
cable in accordance with the following diagrams:
3. Make a note of the serial numbers (10 digits) of your devices to ensure you
can enter them in the app later on.
Sauna heater ................................................................................................
Sauna control unit ........................................................................................
Other products ..............................................................................................
ATTENTION!
Damage to the device!
Installation of the app and input of the settings (see "5. Commissioning") must
be completed before the sauna control unit is switched on.
4.1. Mounting and connecting MySentio WiFi
27.5
Auto
STB
rd wt bk
home.com4
PRO-B series
PRO-C series
PRO-D series
FF
p. 5/8
EN
RJ45
8-pin