Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.
After having fitted the transducer make sure that the cable is protected and made safe along its
entire length.
3.
Pass the cable through the lower hole of the system (the hole where all the pipes and power
cables pass, pos. 16 fig 01, page 39.
4.
Connect to the wires to the terminals according to the sensor model, as in the following table:
5.
Clamp the cable to the internal pipes of the equipment.
! Attention: the suction pipe must be positioned close to the transducer and must not be installed at a
height greater than 5 cm from the pressure transducer (see fig. 06, page 39).
On installation the level indicator indicates that the tank is empty with 0% of the led flashing, with all
led on the level is at 100%.
!
For collecting tanks with a height of less than 2 m, use a pressure transducer with scale 0-2m
WARNING
The transducer automatically reads the level updating the 100% value each time the value of the liquid
in the tank is exceeded, only the real value of 100% is acquired with the tank completely full. The
value of 100% that is indicated during the initial filling stage of the tank can be considered as virtual.
After the initial filling of the tank the values from 10% to 100% correspond to the actual quantity of
water contained in the tank.
Transducer
Bottom of the tank
Sensor
Terminal
model
IN1
MAC3
yellow lead
JUMO
white lead
KELLER
red lead
ENGLISH
Figure 06
Terminal
white lead
brown lead
black lead
50
+V1
Werbung
