Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Maintenance
Caution!
Maintenance work may only be carried out by authorised and suitably
qualified technical staff. Prior to any maintenance work, switch off the unit
and release all pressure.
Cleaning of dirt screen (only necessary with highly contaminated
condensate)
If condensate that is contaminated more than usual is drained, regularly clean the
dirt screen.
► For this purpose, close the compressed air line and the condensate inlet.
► Repeatedly press the test button until no flow noise is audible (depressurising
the drain).
► Disconnect the power supply (remove the plug from the adapter).
► Dismantle condensate outlet by loosening nut (1) and pulling off the hose tail.
► Disconnect the drain:
—
—
► Loosen the screw of the dirt screen (2)
and pull it out of the unit.
► Clean dirt screen.
► Rinse drain with water through the top
condensate inlet (3) to remove any other
dirt
In this way, all dirt can be removed without
having to completely dismantle the entire
condensate drain.
► Insert and secure dirt screen.
► Reinstall condensate drain in the system
► Reconnect condensate outlet and power
supply. Open the compressed air line
and the condensate inlet.
► Restart the drain.
Annual maintenance
Once very 12 months, and irrespective of the actual operating hours, a number of
parts in the condensate drain must be replaced as a precaution. For this purpose,
Zander has assembled the SKED3000 service kit containing these replacement
parts (seals, springs,etc.). When replacing these parts, strictly follow the
instructions in the maintenance manual included in the service kit.
ED3002–ED3100_Int-1_08
ED3002:
remove the condenate drain with complete filter base. The condensate
inlet can be turned.
ED3004, ED3007, ED3030, ED3100:
Loosen optional screw connections and remove the drain.
Operating instructions /
Sectional drawing of condensate drain
EN
27
Werbung
