Parkside PGSA 4 A2 Originalbetriebsanleitung Seite 38

GB MT
Trouble shooting
Problem
Device doesn't
start
Bad cutting results
38
Possible Cause
Equipment is not charged
Switch lock (3) has not been
operated properly
On/off switch (8) may be
defective
Safety key (7) not inserted
Too much friction due to lack
of lubrication
Dirty blade(10/12)
Blade (10/12) is blunt or has
nicks
Blade (10/12) is damaged
Error correction
Charge equipment (see „Charging
process")
Switch on (see „Operation")
Repair by Service Centre
Insert safety key (see "Operation")
Lubricate blade (10/12)
(see „Cleaning/Maintenance")
Clean blade (see „Cleaning/Main-
tenance")
Sharpen blade (see „Cleaning/
Maintenance") or replace (see
„Spare parts/Accessories")
Replace blade (see „Spare parts/
Accessories")