Parkside PGSA 4 A2 Originalbetriebsanleitung Seite 33

a) The charger must only
be connected to a mains
socket via a residual-cur-
rent circuit breaker (RCD)
with a rated leakage cur-
rent of not more than 30
mA. b)
battery, use only the char-
ger supplied. Risk of fire
and explosion. This ensures
that the safety of the device is
maintained.
c) Before each use, check the
charger, cable and plug
and have them repaired by
qualified professionals and
only with original parts. Do
not use a defective char-
ger and do not open it up
yourself. This ensures that the
safety of the device is maintai-
ned.
d) Ensure that the mains
voltage matches the speci-
fications on the charger
rating plate. Risk of electric
shock.
e) Disconnect the charger
from the mains before
closing or opening con-
nection to the battery /
power tool / device. This
ensures that the battery and
charger are not damaged.
To charge the
f) Keep the charger clean
and away from wet and
rain. Do not use the char-
ger outdoors. Dirt and the
entry of water increase the risk
of electric shock.
g) The charger must not be
operated on or in the im-
mediate vicinity of flam-
mable surfaces (e.g. pa-
per, textiles). Risk of fire due
to heating caused by charging.
h) Avoid mechanical damage
to the charger. This can result
in internal short circuits.
i) Do not operate the charger
on a combustible surface
(e.g. paper, textiles). Risk of
fire due to heating during char-
ging.
j) Do not use the charger to
charge non-rechargeable
batteries.
l) Do not connect a damaged
cable to the power supply.
Do not touch a damaged
cable before it has been
disconnected from the po-
wer supply, as you could
come into contact with ac-
tive parts.
GB MT
33