Parkside PGSA 4 A2 Originalbetriebsanleitung Seite 26

GB MT
Sound power level (L
guaranteed ............................... 77 dB
measured ......... 74.1 dB; K
Vibration (a )
h
at handle ......... 0.92 m/s
Temperature (device & battery) ...max. 50 °C
Charging process .................. 4 - 40 °C
Operation ..........................-20 - 50 °C
Storage ................................ 0 - 45 °C
Battery (Li-Ion) ............................ Li-Ion
Nominal voltage .............. 4 V
Power supply unit ..........................
................ WJG-Y130502200WU1/
...................WJB-Y130502200WU1
Grizzly Tools GmbH & Co. KG
Stockstädter Straße 20
DE-63762 Großostheim
HRA: 5468, Amtsgericht Aschaffenburg
Input voltage ............................100-240 V~;
Input AC frequency .......................50-60 Hz
Power input ................................. 25 W
Rated output ................................ 5 V
Output current ......................... 2200 mA
Output power ............................ 11.0 W
Average active efficiency ............. 82.9 %
Efficiency at low load (10%) ......... 83.1 %
Power consumption at zero load .. 0.08 W
Protection class ...............................
Protection category...........................IPX0
The noise and vibration levels have been
calculated according to the norms stated in
the conformity statement.
The specified noise emission value has
been measured according to a standardi-
sed testing method and may be used for
comparison with another power tool.
The specified noise emission value can
also be used for a provisional assessment
of the load.
26
)
WA
= 2.47 dB
WA
2
, K=1.5 m/s
; 2 Ah
Warnung: -The vibration emission
value may differ during actual use of
the power tool from the stated value depen-
ding on the manner in which the power tool
2 is used.
Try to keep the exposure to vibrations as
low as possible. Examples of measures to
reduce vibration exposure are the wearing
of gloves when using the tool and limiting
the working hours. For this purpose all parts
of the operating cycle have to be consi-
dered (for example, times when the electric
tool is switched off and times when it is swit-
ched on but running without any load).
Safety Instructions
This unit can cause serious in-
jury if not used correctly. Be-
fore using the unit, carefully
read through the instruction
manual and familiarise your-
self with all of its controls.
Symbols
Symbols in the manual
Warning symbols with in-
formation on damage and
II injury prevention.
There is a risk of injury from
electric shock.
Instruction symbols with information
on preventing damage.
Help symbols with information on
improving tool handling.
Wear anti-slip safety shoes.