Parkside PGSA 4 A2 Originalbetriebsanleitung Seite 35

2. Press the blade into the direction of the
cutter head (1). It locks into place audi-
bly.
Remove the blade:
3. Press the release button (9) on the
cutting head (1) and remove the entire
blade.
Switching on and off
1. Remove the blade guard (11/13) be-
fore switching the unit on.
2. Insert the safety key (7) into the device.
3. To switch on, hold the switch lock
(3) depressed and operate the on/
off switch (8). Then release the switch
lock.
The equipment runs at top speed.
4. In order to switch off, let go of the on/
off switch (8).
After switching the unit off,
the blades take a short time
to stop moving. Let the blades
come to a complete standstill.
Do not touch the blades or
slow them down before the
moving parts have come to a
standstill.
General­working­instructions
While trimming, take care that there
are no objects such as wire, metal
parts, stones etc. come into contact
with the blades. This can lead to
cutting head damage. If the blades
become blocked by solid objects,
switch off the unit at once.
• Check the grass and bush trimmer blades
for obvious defects such as loose, worn
or damaged parts. Check that the screws
are seated firmly in the blade block.
• Remove the power supply unit before
working with the equipment. Do not
use extension cables. The power sup-
ply unit is to be used only in enclosed
spaces.
• Only use sharp blades to achieve a
good cutting performance and pre-
serve the battery.
• Do not work the unit so hard that it
comes to a standstill.
• Pay attention to the instructions on unit
maintenance and cleaning.
Use as a grass trimmer
Grass is best cut when dry and not too long.
Adjusting the working angle
For a comfortable edge cut, the cutter head
(1) can be rotated by 90° in both direc-
tions.
The cutter head (1) features 3 positions:
+90°, 0°, -90°.
1. Operate the unlocking mechanism (4)
and turn the cutter head (1) into the
desired position.
2. Release the unlocking mechanism (4) so
that the cutter head (1) locks into place.
Use as a hedge trimmer
• Move the unit forward evenly.
• The double-sided cutting heads enable
cutting in both directions or by swing-
ing the unit from side to side.
GB MT
35