Standard Equipment; Preparing The Machine For Operation; Assembling The Handlebar; Installing Protective Sleeve - Viking MB 756 GS Gebrauchsanleitung

Stop position
Start the engine, engage the mowing
blade.
Disengage the mowing blade.
Switch on self-propulsion.

6. Standard equipment

Item Designation
A Basic unit with handlebar
B Grass catcher bag frame
C Grass catcher bag fabric
D Grass catcher bag flap
E Cable tie
F Protective sleeve
−
Instruction manual
0478 111 9925 C - EN
Item Designation
−
Engine instruction manual
MB 756 GS, MB 756 YS:
G Flat head bolt
H Lock nut
7. Preparing the machine for
operation
Risk of injury:
Observe the safety instructions in
the section "For your safety" (
● Place the machine on level and firm
ground when performing all the
operations described.

7.1 Assembling the handlebar

MB 756 YC:
● 1 Remove screw (1) with
washer (2). Loosen screws (3).
● 2 Push handlebar (4) into handlebar
attachment (5) and fold up until the slot
in the handlebar is above the bore in the
housing, making sure that the cables
are lying correctly (see illustration).
● 3 Install screw (1) with washer (2),
making sure that the screw also
extends into guard plate (6).
2
● 4 Tighten screws (3) to 21 - 29 Nm.
Qty.
Set the handlebar to the desired
working height and hold, tighten
1
screw (1).
1
● Check correct assembly:
1
The handlebar must be firmly located
1
with the cables to the rear and outside
2
of the handlebar.
1
1
MB 756 GS, MB 756 YS:
Qty.
● 1 Guide upper handlebar (1)
1
with the open ends into lower
handlebars (2) and hold. Insert
4
bolts (G) from the outside inwards
4
through the bores, fit lock nuts (H) and
tighten to 19 - 27 Nm.
● 2 Set the handlebar to the desired
working height and hold, tighten
screw (3).
● Check correct assembly:
The upper handlebar must be firmly
4.).
connected to the lower handlebar with
the cables to the rear and outside of the
handlebar.

7.2 Installing protective sleeve

● Insert all cables in protective
sleeve (F).
3
● Guide cable tie (E) through the top
opening in right lower handlebar (1) and
use to fasten protective sleeve (F).
● Fasten protective sleeve (F) to right
upper handlebar with cable tie (E) as
shown.
Prior to initial operation, the cables
must be checked and adjusted if
necessary. (

7.3 Single-wheel cutting height

adjustment
The cutting height can be adjusted
to six different positions at each wheel
using a corresponding lever.
Lowest cutting height (1): 25 mm
Highest cutting height (6): 90 mm
4
5
11.9)
6
41