Herunterladen Inhalt Inhalt Diese Seite drucken

Standard Equipment; Preparing The Machine For Operation; Assembling The Handlebar (Mb 4 R, Mb 4 Rt, Mb 4 Rv); Assembling The Handlebar - Viking MB 4 R Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für MB 4 R:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 11
MB 4 RV:
Set the driving speed.
(
11.3)
MB 4 RTP:
Wear hearing protection
when working.
Service position marking on
the detent segment.
(
12.1)

6. Standard equipment

Item
Designation
A
Basic unit with handlebar
Instruction manual
Engine instruction manual
MB 4 R, MB 4 RT, MB 4 RV:
B
Cable clips
C
Flat head bolts
D
Quick-clamping devices
E
Protective sleeves
0478 111 9929 B - EN
All manuals and user guides at all-guides.com
Item
Designation
MB 4 RTP:
B
Cable clips
F
Flat head bolts
G
Retaining washers
H
Lock nuts
I
Protective sleeves
7. Preparing the machine for
operation
7.1 General
Risk of injury!
Observe the safety instructions in
the section "For your safety" (
● Place the machine on level and firm
ground when performing all the
operations described.

7.2 Assembling the handlebar

(MB 4 R, MB 4 RT, MB 4 RV)
● Fit protective sleeves (E) onto
upper handlebar (1) with the long side
facing inwards.
2
● Hold upper handlebar (1) on lower
Qty.
handlebar (2) and insert screws (C)
1
through bores (3) from the inside
1
outwards.
1
● Screw in quick-clamping device (D) at
screws (C) (it should project by about
one screw thread turn) and fold
upwards.
2
2
2
2
● Check correct assembly:
Qty.
Quick-clamping devices (D) must be
sufficiently tightened so that they are
2
pressed tightly against the handlebar
2
and the upper handlebar is firmly
connected to the lower handlebar.
2
If the handlebar is not firmly installed or
2
the quick-clamping devices are not
2
correctly located, fold open the quick
clamping devices and adjust them to
the correct position by screwing out and
in.
7.3 Assembling the handlebar
(MB 4 RTP)
● Fit protective sleeves (I) onto
upper handlebar (1) with the long side
4.).
facing inwards.
● Hold upper handlebar (1) on lower
handlebar (2) and insert screws (F)
through bores (3) from the outside
inwards. Fit retaining washers (G) and
lock nuts (H) and tighten.
Tightening torque:
3
22 - 28 Nm
● Check correct assembly:
The upper handlebar must be firmly
fastened to the lower handlebar.

7.4 Installing the cable clips

● Press cable clips (B) onto the
upper handlebar as described
below. Insert the cables into cable
clip (B) as shown, close tab (4) and
allow it to engage.
● MB 4 R:
Fasten motorstop cable (1) to the left
upper handlebar using cable clip (B).
4
5
37

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Mb 4 rtMb 4 rvMb 4 rtp

Inhaltsverzeichnis