Standard Equipment; Preparing The Machine For Operation; General; Installing Mono Handlebar (Ma 443 C) - Viking MA 443 Gebrauchsanleitung

6. Standard equipment

Item Designation
A Basic unit
B Upper part of grass catcher
box
C Lower part of grass catcher
box
D Pin
N Safety plug
O Battery
P Charger
– Instruction manual
MA 443:
E Quick-clamping device
F Bolt
G Cable guide
H Cable clip
I Protective sleeve
MA 443 C:
J Sleeve
K Bolt
L Washer
M Nut
The standard equipment may vary
depending on the country and
version type.
0478 131 9922 D - EN
All manuals and user guides at all-guides.com
7. Preparing the machine for
operation
2

7.1 General

Qty.
Risk of injury!
1
Observe the safety instructions in
1
the section "For your safety" (
Remove the safety plug,
1
particularly before
performing any work on the lawn
2
mower ( 9.1).
1
● Place the machine on level and firm
ground when performing all the
operations described.
1
Upon delivery, the batteries are
charged to approx. 30%. They must
be therefore be charged before
2
being used for the first time.
2
● Charge battery (
1
1
2
7.2 Installing mono handlebar
(MA 443 C)
1
● 1 Insert sleeve (J) in the bore
1
on handlebar (1).
2
● 2 Fit two washers (L) with the convex
1
side facing inwards onto the sleeve.
● 3 Hold sleeve (J) and washers (L) and
insert together with handlebar (1) into
handlebar console (2).
● 4 Insert nut (M) into the handlebar
console as shown.
● 5 Insert bolt (K) from the outside
inwards through the bores in
handlebar (1) and in handlebar
console (2) and tighten.
Tightening torque:
18 - 22 Nm
Installing electric cable:
● Press electric cable (3) into the holders
on the handlebar console and
4.).
handlebar (4, 5) as shown and fasten to
the handlebar using cable clip (6).
7.3 Installing dual handlebar
(MA 443)
● Fit the protective sleeves (I) onto
the lower handlebars (1).
● Insert the screw (F) through the bore in
the cable guide (G).
● Fit the upper handlebar (2) onto the
lower handlebar sections (1).
8.4).
● Attach the cable guide (G) to the
electric cable (3) and insert the
screw (F) through the bore from the
inside outwards.
3
● On the opposite side, insert the
screw (F) from the inside outwards
through the bores.
● Screw the quick clamping devices (E)
onto the screws (F) (the screw should
project by about one screw thread turn)
and fold upwards.
4
41