Bosch SCT 416 L1 Originalbetriebsanleitung Seite 11

1. Symbols used
1.1 In the documentation
1.1.1 Warning notices -
Structure and meaning
Warning notices warn of dangers to the user or
people in the vicinity. Warning notices also indicate
the consequences of the hazard as well as preventive
action. Warning notices have the following structure:
Warning
KEY WORD – Nature and source of hazard!
symbol
Consequences of hazard in the event of
failure to observe action and information
given.
¶
Hazard prevention action and information.
The key word indicates the likelihood of occurrence
and the severity of the hazard in the event of non-
observance:
Key word Probability of
occurrence
DANGER Immediate impending
danger
WARNING Possible impending
danger
CAUTION Possible dangerous
situation
1.1.2 Symbols in this documentation
Symbol Designation Explanation
Attention Warns about possible property damage.
!
Information Practical hints and other
i
useful information.
1. Multi-step Instruction consisting of several steps.
2. operation
One-step Instruction consisting of one step.
e
operation
Intermediate An instruction produces a visible

result intermediate result.
Final result There is a visible final result on
"
completion of the instruction.
1.2 On the product
!
Observe all warning notices on products and ensure
they remain legible.
Robert Bosch GmbH
Severity of danger if
instructions not observed
Death or severe injury
Death or severe injury
Minor injury
Symbols used | SCT 416 L1; ACC 100/200 | 11
2. Important notes
Prior to commissioning, connecting and
operating Bosch products,
it is absolutely essential to work through the
operating instructions/manuals and in particular the
safety notes with care. By doing so you can eliminate
any uncertainties when handling
Bosch products and any associated safety risks up
front, something which is in the interests of your own
safety and
will ultimately help prevent damage to the device.
Whoever passes a Bosch product onto another person
must hand over,
in addition to the operating instructions, the safety
instructions and
information on the intended use to this person as well.
!
National laws, guidelines and standards must be
observed! Robert Bosch GmbH does not accept any
liability for damage arising from non-observance of
local regulations.
2.1 Intended use
¶
The SCT 416 L1; ACC 100/200 is intended only
for static calibration of sensors and cameras on
vehicles. The repair and service instructions specific
to the vehicle manufacturer are authoritative. Any
other or additional application does not constitute
intended use.
¶
The SCT 416 L1; ACC 100/200 may be used only by
trained and briefed personnel. The manufacturer
(Bosch GmbH) assumes no liability for possible
damage arising from improper, incorrect or negligent
use.
¶
Make sure operating and safety instructions are
always to hand at the usage location.
¶
Heed all the safety instructions and hazard warnings
on the SCT 416 L1; ACC 100/200 and make sure
these are always complete and clearly legible.
¶
Operate the SCT 416 L1; ACC 100/200 and the
accessories required for testing only within your
specific work area.
¶
Before using the SCT 416 L1; ACC 100/200, ensure
that the test equipment is correctly set up and
connected.
¶
Observe the intervals specified or given in
the operating instructions for routine checks/
maintenance.
¶
Maintenance work is never to be performed during
operation. Shut-off the unit prior to performing
maintenance.
¶
Follow the instructions for switching on and off
stipulated in the operating instructions along with
the notes for repairs when performing any work!
| en
|
1 690 386 045 2018-10-26