Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TRD0305- ETAC Mounting Hardware Installation Instructions- Europe, Rev 1.0_Layout 1 29/02/2012 12:43 PM Page 7
5.0 ETAC Recline Adjustments (for greater seat depth)
NOTE: For users that require maximum depth for their back cushion, it may be
necessary to adjust the recline angle of the ETAC back canes in order to maximize the
seat depth, and provide better access to the adjustment hardware.
Adjusting the Recline Angle of the Back Canes
1
Image (1) illustrates a back installed at the maximum
depth, and the ETAC back canes in their upright (non-
reclined) position. (Note: As shown in this configuration,
access to the adjustment hardware can be difficult)
2
To increase the recline angle of the ETAC back canes,
loosen the 13mm nut at the bottom of each back cane
(2). Adjust the recline angle via the slotted channel at
the bottom of each back canes (3). (Note: Ensure that
both back canes are adjusted equally). Following the
recline adjustments, the mounting plates may also require
adjustment to compensate for revised back cane angle.
Upright
back cane
position
3
Image (4) shows the ETAC back canes in the re-
clined position with the ETAC mounting hardware
re-adjusted to compensate for the new recline
angle. This reclined back cane configuration
creates more available space for depth adjustment,
and improves access to the adjustment screws/
hardware.
- 7 -
2
13 mm
Nut
Recline Angle
Adjustment
1
Fully recline
back cane
3
4
Werbung
Inhaltsverzeichnis
