Kärcher Inno-Foam-Set Bedienungsanleitung Seite 8

! Slide O rings onto the injector insert and
coat lightly with silicone grease.
! Slide injector insert into the injector and
tighten fingertight using a 12x2 flat tip
screwdriver.
! Screw on adapter and tighten.
1 Screw
2 Safety clip
3 Push handle
! Loosen screws.
! Pull out the safety clip.
! Pull the push handle upward.
1 Injector
2 Safety clip
! Insert the injector into the appliance.
! Slide the push handle down until the in-
jector is situated in the connection of
the hose drum.
! Insert both safety clips.
! Fix in the screws and tighten them.
8
English
Install reversible spray pipe (only
Inno-Foam set)
! Unscrew serial/standard spray pipe
from the the handgun.
! Install the reversible spray pipe on the
handgun.
! Install the standard high pressure noz-
zle onto the long pipe of the reversible
spray pipe.
Install foam nozzle
1 Foam nozzle
2 Round jet nozzle
3 O ring
4 Mould part
5 Spray pipe/reversible spray pipe
! Insert the O ring into the ring groove of
the mould part.
! Slide the round spray nozzle onto the
pin of the mould part.
! Insert the nozzle with mould part into
the foam nozzle.