Kärcher Inno-Foam-Set Bedienungsanleitung Seite 7

Please read and comply with
these instructions prior to the
initial operation of your appliance. Retain
these operating instructions for future refer-
ence or for subsequent possessors.
In the event of missing parts or any trans-
port damage, please contact your dealer.
Contents
Safety instructions
Application
– The machine with working equipment
must be checked to ensure that it is in
proper working order and is operating
safely prior to use. Otherwise, the appli-
ance must not be used.
– The machine may not be modified.
Operations
– Never reach your hands into the high
pressure jet.
– Never direct the high pressure jet on
persons or animals.
Environmental protection
The packaging material can be
recycled. Please do not place
the packaging into the ordinary
refuse for disposal, but arrange
for the proper recycling.
Old appliances contain valuable
materials that can be recycled.
Please arrange for the proper re-
cycling of old appliances. Batter-
ies, oil, and similar substances
must not enter the environment.
Please dispose of your old appli-
ances using appropriate collec-
tion systems.
Proper use
– The foam set is used to clean and disin-
fect floors and wall surfaces and ma-
chines with a high pressure cleaner.
– Adding 5% of a cleaning solution is suf-
ficient.
– The water pressure must not exceed 25
MPa (250 bar).
– The water temperature must not ex-
ceed 50 °C during foam operation.
– The water flow must be at least 500 l/h
(8.3 l/min).
– The high pressure hose must not be
longer than 15 m.
– The use of cleaning agents containing
chlorinated alkalies leads to increase
wear and tear of the appliance.
Assembly
Install the injector
– The injector suctions cleaning agents
and mixed them into the water stream.
– This suction effect will only be created if
the included round jet nozzle is integrat-
ed in the foam nozzle.
! Switch off the high pressure cleaner.
! Interrupt current and water inflow.
! Activate hand spray gun until device is
pressure-less.
1 O ring
2 Injector
3 Injector insert
4 Adapter
7
English