Herunterladen Diese Seite drucken

Nilfisk BA 700 Bedienungsanleitung Seite 32

Werbung

Squeegee Maintenance
If the squeegee leaves narrow streaks of water, the blades may be dirty or damaged. Remove the squeegee, rinse it under warm water and
inspect the squeegee blades. Reverse or replace the blades if they are cut, torn, wavy or worn.
To Reverse or Replace the Rear Squeegee Wiping Blade...
1
Unsnap the center Latch on the squeegee tool.
2
Remove the Wing Nut from each end of the squeegee, then remove the Tension Straps.
3
Slip the rear blade off the Alignment Pins.
4
The rear squeegee blade has 4 working edges. Turn the blade so a clean, undamaged edge points toward the front of the machine and
against the floor. Replace the blade if all 4 edges are nicked, torn or worn.
5
Install the blade, following steps 1-3 in reverse order.
The 4 Wiping Edges of the Rear Blade
C
A
To Reverse or Replace the Front Squeegee Blade...
1
Put the Squeegee Lever in the UP position and remove the vacuum hose from the squeegee tool.
2
Loosen the two thumb screw on top of the squeegee, and slide the squeegee tool off of the squeegee mount.
3
Remove the nuts that hold the front blade in place, then remove the blade.
4
The front squeegee blade has 4 working edges. Turn the blade so a sharp 90° edge points toward the front of the machine and against
the floor. Replace the blade if all 4 edges are nicked, torn or worn.
5
Install the blade, following steps 1-3 in reverse order.
6
Put the squeegee tool back on the machine, connect the vacuum hose, and adjust the squeegee.
Adjusting the Squeegee (before serial # 1081111)
The squeegee should be adjusted whenever the squeegee is not wiping the floor dry.
To Adjust the Squeegee Tool...
1
Park the machine on a flat, even surface.
2
Turn the Master Switch (11) OFF and lower the Squeegee Lever (10).
3
Turn the Adjustment Knob until the rear squeegee blade touches the floor across its entire width
32 - FORM NO. 041289 / BA 700, BA 800, BA 1000
D
B
Wing Nut
Thumb Nut
Adjustment Knob
Retaining Strap
Alignment Pin
Rear Squeegee Blade
Squeegee Mount
Vacuum Hose Connection
Latch

Werbung

loading

Diese Anleitung auch für:

Ba 800Ba 1000