CO/Tech RH01-E-1 Bedienungsanleitung Seite 7

Product description
1
5
8
1. Temperature sensor
with 2 m cable
2. Housing
3. Heat output grille
4. Heating coil
Installation
The frost guard must be mounted in such a way that the air
flow is not blocked or hindered. The appliance will become
hot during use so it is important that the specified minimum
safe distance to combustible material is observed.
1. Remove all the packaging material and check that
the appliance is intact.
2. Select
an appropriate
location to mount
the appliance.
The appliance
must be installed at
least 10 cm above
the floor and at
least 50 cm below
the ceiling.
2
7 6
3
5. Mounting hole
6. [ 0/1 ] on/off power switch
7. Temperature control
8. Power lead with plug
7
4
5