Product Description - CO/Tech ZHQ1288-RMHD-65 Bedienungsanleitung

Product description

The infrared heater utilises a highly efficient gold-coloured
short wave heating element. It generates full heat
immediately and it emits up to 20% more heat than
older infrared heaters and converts most of the energy
to heat. The short wave infrared light can be compared
to the sun's radiation and only heats people within
the heater's immediate area instead of the surrounding
air, even in windy conditions. The coating on the heating
element also filters the visible light to a more comfortable
light that does not dazzle.
1. Handle
2. [ ] On/standby, indicator lamp
3. Safety grille
4. Heating element
5. [ 0, I ] Main power switch, on/off
Instructions for use
Note
The infrared heater is fitted with a tip-over switch which switches the heater off
if it falls over. Press [
The product will become very hot during use and could cause burns.
Special care must be taken if the product is used in the same room
as children, aged or infirm persons.
Assembly
1. Screw the base plate into place using
the three 25 mm M6 screws.
2. Plug the product into a wall socket.
] (2) to switch the infrared heater on again.
5
1
2
3
4
5