Beko HNU51630SH Bedienungsanleitung Seite 14

5 Setting up the device
5.3 Installation of the appliance
A
Use protective gloves and glasses
while performing drilling and cutting
operations.
A
Th�s area shows the d�mens�ons of furn�ture cutt�ng.
Bu alan mob�lya kes�m ölçüler�n� göstermekted�r.
MOUNTING TEMPLATE SCALE 1:1
MONTAJ ŞABLONU SKALA 1:1
C
ELECTRO
650 mm
ELEKTRİKLİ
WORKTOP
TEZGAH
Figure 1
5.4 Drilling mounting holes
• Adhere the installation template provided with
the appliance onto the surface on which the in-
stallation will be carried out.
• Drill the holes indicated on the installation draft
with A, B, C, D using a Ø4 mm drill bit. (Figure 1)
Figure 2
• Cut the lower surface of the cabinet where the
hood will be installed in the dimensions speci-
fied in the technical drawing (Figure 2).
14 / EN
508
570
530
B
386
A,B,C,D = Ø3
D
GAS
650 mm
GAZLI
H670.1170.0 5.01
Figure 3
1. Flap Pin Socket
2. Flap Pin
Insert the plastic pin (Figure 3/area no. 2) on the
pin socket on the motor exhaust (Figure 3/area
no.1). Then bend the flap lightly to insert the other
pin on the flap and insert the other pin to its socket
(Figure 3).
Figure 4
1. Air discharge pipe
2. Air exhaust flue of the hood
If you are to use the Ø 120/150 mm plastic flue
adapter, attach one end of the pipe to this adapter;
if not, attach the air discharge pipe of the prod-
uct to the air outlet flue of the extractor hood and
tighten it with the help of a clamp (Figure 4).
Cooker Hood / User Manual
1
2