Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Insert one end of the hose into the air intake and another end of the hose into the center
hole of the canister cover.
Check the LED status of "vacuumstrengh" and make sure if it is in "normal" setting.
Close the cover. Turn the lever clockwise until the cover is latched.
Press the "Behälter" (Canister) button to start vacuuming. To ensure there is no air leaking
between the cover and the canister, use your hand to push down the cover at the
beginning of the vacuuming work. The machine will stop automatically when enough
vacuum pressure is achieved. Take out the hose tube from the canister or bowl
immediately first after the job is completed.
16.8 Use of the cutter
To cut the foil at desired length, press the cutter unlock buttons on both sides. Press down
the cutter so that the foil is held firmly. Slide the cutter over the foil.
Push it back into place until it latches.
16.9 Opening a sealed bag
Cut the bag straight across with scissors or the cutter, just inside the seal.
16.10 Storage
Store the unit in its upright position, out of the reach of children.
► Always unplug the appliance from its outlet immediately after using
and before cleaning.
► For the correct storage, please slightly close the cover, do not lock,
it will deform the gaskets and affect the machine function
(STORE).
17 Cleaning and Maintenance
This chapter provides important information on properly cleaning and maintaining your
vacuum sealer.
17.1 Safety information
Danger
Please observe the following safety notices, before cleaning the unit to avoid
damage to the unit or personal injury:
► To ensure optimum performance, the unit must be cleaned regularly. Failure to clean
the unit regularly can lead to potential malfunctions, as well as safety and health risks.
► Unplug the device before cleaning.
► The sealing strip remains hot after use. Wait a few minutes until the strip has cooled
before cleaning.
PLEASE NOTE
43
Werbung
