Test Symbols; Appliance Description - STIEBEL ELTRON DEM 3 Bedienungsanleitung

oPErATIoN

Appliance description

WARNING Injury
!
The appliance may be used by children aged 3 and up and
persons with reduced physical, sensory or mental capa-
bilities or a lack of experience and know-how, provided
that they are supervised or they have been instructed on
how to use the appliance safely and have understood
the resulting risks. Children must never play with the
appliance. Children must never clean the appliance or
perform user maintenance unless they are supervised.
DANGER Electrocution
Any damaged power cables must be replaced by a qual-
ified electrician. This prevents potential hazards from
arising.
Material losses
!
Protect the appliance and tap against frost.
Material losses
!
Only use the special aerator provided. Prevent scale
build-up at the tap outlets (see chapter "Cleaning, care
and maintenance").
www.stiebel-eltron.com
2.3

Test symbols

See type plate on the appliance.certificate has been issued for
these appliances, as verification of their suitability regarding noise
emissions.
3. Appliance description
The electronically controlled mini instantaneous water heater
maintains a constant outlet temperature up to its output limit,
irrespective of the inlet temperature.
This appliance has been factory-set to the outlet temperature
required for washing hands. Once this temperature has been
reached, the PCB automatically reduces the output. The output is
matched to the required temperature, this prevents the temper-
ature being exceeded.
The appliance heats the water directly at the draw-off point as
soon as the tap is opened. The short pipe runs ensure that energy
and water losses are minimal.
The DHW output depends on the cold water temperature, the heat-
ing output and the flow rate.
The bare wire heating system is suitable for hard and soft water
areas. This heating system has a low susceptibility to scale build-
up. The heating system ensures quick and efficient DHW provision
at the hand washbasin.
Your qualified contractor can adjust the maximum temperature
and flow rate (see chapter "Commissioning / Settings").
DEM | 35