General Use; Turning On/Off; Navigating The Menu; Memory Function - VOLTCRAFT CT-20TDR Bedienungsanleitung

10. geNeRAL Use

a) Turning on/off
1. Push the on/off button (5) to turn on the cable tester. An audible signal sounds, provided audible
signals have not been deactivated under settings (see "11. DEVICE SETTINGS"). After the
welcome message, "SELECT MODE..." appears on the display.
2. Push the on/off button again to turn off the cable tester. The display goes out.
After 5 minutes without any input, the cable tester turns off automatically. In locate mode
("TONE MODE") after 30 minutes.
b) Navigating the menu
Use the navigation buttons (16) to navigate the menu when the device is turned on:
- (up), (right),
c) selecting a test mode
The following test modes are available:
- LAN MODE:
- TEL MODE:
- COAX MODE:
- TONE MODE:
- LENGTH MODE: check/measure cable lengths
Select a test mode using the buttons LAN (20), TeL (19), COAX (18), TONe (7) and LeNgTH (6).
All test modes are described in the corresponding chapters.
d) memory function
The cable tester can save test and measuring readings:
- LAN MODE, TEL MODE:
- COAX MODE, LENGTH MODE: max. 4 memory slots
Saving test / measuring readings:
While the reading you wish to save is shown on the display, push and hold the memORY button (17)
for ca. 2 seconds. After the button is released, the display will briefly show "MR-X". Here, "X" stands
for the memory slot (for example, MR-5, memory slot 5).
32
(down), (left)
LAN cable test
telephone cable test
coax cable test
locate mode
max. 8 memory slots