Length Mode - VOLTCRAFT CT-20TDR Bedienungsanleitung

16. LeNgTH mODe

LeNgTH mode: Measure LAN and coaxial cable lengths.
Review the following display overview for length mode before beginning measuring:
LENGTH MODE
LAN Cable
2
Pair1: 23.8 M
3
Ill. 5
1 Mode
2 Cable type (LAN or COAX)
3 Pair of conductors 1 – 4 (only for LAN cables)
4 Length ("OVER" is displayed for lengths > 350 m)
5 In combination with the remote test port, "Keep OPEN" is displayed
a) Connection
Connect the LAN or coaxial cable to the RJ45 jack mAIN (3) or the F connector f (2).
Also see the chapters "LAN MODE" and "COAX MODE".
Measurement is conducted with the remote test port. Disconnect the cable from the remote test port.
b) Conducting a test
1. Turn on the cable tester and push the LeNgTH button. Or select "5. LENGTH MODE" using the
navigation buttons and confirm with the TesT button.
2. Use the navigation buttons (up and down) to select the cable type ("LAN" or "COAX").
3. Push the LeNgTH or TesT button to begin testing. The test result can be read on the display.
See Ill. 5.
- Only LAN cables: Use the navigation buttons (left and right) to display the length of a pair of
conductors (1 – 4).
40
LENGTH MODE
1
4
Keep OPEN
COAX Cable
Length: OVER
5