Intended Use - VOLTCRAFT CT-20TDR Bedienungsanleitung

2. INTeNDeD Use

Use this cable tester to test 2- to 8-pin cables and connector shielding with the following
connections: RJ45, RJ11 and F connectors.
The device has 5 test modes: LAN cable mode, telephone cable mode, coax cable mode, locate
mode and length mode.
Length and fault location is possible with cable lengths of 1 – 350 m.
The display shows the test results.
Only conduct measurements on voltage-free systems.
The cable tester is designed for battery operation only.
The device is intended exclusively for indoor use, do not use outdoors. Avoid contact with moisture –
such as via use in bathrooms, etc. – at all costs.
This product complies with the statutory national and European requirements.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you
use the product for purposes other than those described above, the product may be damaged. In
addition, improper use can cause hazards such as short circuiting, fire, electric shock etc. Read the
instructions carefully and keep them. Make this product available to third parties only together with
its operating instructions.
Heed all safety instructions and information in this manual.
25