Special Safety Instructions; Before Initial Operation; Fitting The Connector Nipple; Fitting The Grinding Disc - Parkside PDEXS 150 B2 Originalbetriebsanleitung

■ If universal rotary joints (claw couplings) are
GB
used, locking pins must be used to provide pro-
IE
tection; Whipchek
used to provide protection in case of a failure
of the connection of the hose to the machine.
■ Ensure that the maximum permissible pressure
stated on the machine is not exceeded.
■ Never carry compressed-air-powered machines
by the hose.

Special safety instructions

■ Always wear eye protection when using
or maintaining the sander.
■ Always wear suitable protective clothing.
Protect your hands, hair and clothes from being
drawn in by rotating parts.
■ Always wear a dust mask in situations in
which large amounts of dust are being
generated.
■ Always wear hearing protection.
■ Always wear protective gloves.
■ Only connect the sander to the compressed air
network when it is switched off.
■ Sparks are created during grinding. Ensure that
nobody can be endangered by flying sparks.
You should also remove any flammable materials
or objects.
■ Do not carry the grinder if it has been connected
to the compressed air hose.
■ Be aware of the danger caused by a flailing
compressed air hose!
■ The grinder is not approved for use with cutting discs!
■ The flow pressure of 6.3 bar may not be
exceeded during operation.
■ Never use oxygen or other flammable gases as
an energy source.
■ Switch the appliance on before applying it to the
workpiece. After completing the task, lift the ap-
pliance from the workpiece and then switch it off.
■ Once you have completed your work, switch
the grinder off and place it down securely once
it has come to a standstill.
Caution! Grinder continues to run.
6
® air hose restraints must be
■ Once you have completed your work, disconnect
the grinder from the compressed air supply.
■ Be aware that when processing certain materials
there is a danger that dust and vapours can arise
that could create an explosive atmosphere.
Use vacuum cleaners and suitable protective
equipment.

Before initial operation

NOTE
► The grinder may only be operated on cleaned,
oil-atomised compressed air and may not
exceed the maximum operating pressure of
6.3 bar at the appliance. The compressor
must be fitted with a pressure reducer to
regulate the working pressure.
► Wind the Teflon tape
threaded connectors.

Fitting the connector nipple

♦ Remove the plastic protective cap from the
appliance's air inlet.
♦ Wrap the threads on the connector nipple
with the Teflon tape
♦ Screw the connector nipple

Fitting the grinding disc

The compressed air-powered random orbital
sander is equipped with a protective cuff
■ Rotation direction indicator of the
grinding disc
♦ To fit or replace the grinding disc
protective cuff (see Fig. 1).
Fig. 1
supplied around all
supplied.
into the air inlet.
.
.
invert the
PDEXS 150 B2